C1TabControl and AutomationProperties.AutomationId

Posted by: uhlmandanl on 24 June 2021, 1:42 am EST

  • Posted 24 June 2021, 1:42 am EST

    When viewing a UWP UI using Inspect.exe we are unable to see the automation id we have set in XAML for the C1TabControl or the C1TabItems it contains. Is this a defect or is there something else we need to do?
  • Replied 24 June 2021, 6:05 pm EST

    Hi Dan,

    In order to enable automation support for C1 UWP controls, you need to install C1.Xaml.UWP.Automation NuGet package.

    Could you please try the same and see if you still face any issue?

    Best Regards,
    Kartik
  • Replied 25 June 2021, 12:05 am EST

    Kartik,

    Thanks for the reply. We have version 10.0.20181.587 of the controls installed. The earliest C1.Xaml.UWP.Automation package I find is 10.0.20183.611. Will that cause any issues? It appears to work.

    Thanks again,
    Dan
  • Marked as Answer

    Replied 27 June 2021, 10:03 pm EST

    Thanks for the reply. We have version 10.0.20181.587 of the controls installed. The earliest C1.Xaml.UWP.Automation package I find is 10.0.20183.611. Will that cause any issues? It appears to work.

    Hi Dan,


    Yes, you can use C1.Xaml.UWP.Automation(10.0.20183.611) with the 10.0.20181.587 build only if your license is valid for 2018V3 build. However, if that's not the case then you would need to upgrade.

    Just in case needed, I have attached C1.Xaml.UWP.Automation library for build 10.0.20181.587. (see C1.Xaml.UWP.Automation.zip)

    Note: You can find the dll at location '10.0\references\commonconfiguration\neutral' after extracting the attached file.

    Best Regards,
    Kartik

    C1.UWP.Automation.zip
  • Replied 27 June 2021, 11:43 pm EST

    Hi Kartik,

    Thanks for the help. We appreciate it.

    Dan
Need extra support?

Upgrade your support plan and get personal unlimited phone support with our customer engagement team

Learn More

Forum Channels